Behemoth prints 300mm tall PLA rocket section

This is the second PLA rocket I am building.  The first one flew well and is ready for another flight.  See it here.  The bottom section of this rocket is 300mm  tall.  I will print a 300mm tube and a 70mm nose cone for a total height of 670mm.

The layer alignment on this section is the best I have ever seen on any of the printers I have built.  I was worried about issues surfacing as I printed at higher and higher elevations.   So far I have not had any.  This one was printed at 0.35mm layer height and took about 2 hours to print.

I measured the Z height again and I can print 390mm high.

Leave a Reply

Your email address will not be published. Required fields are marked *